Transmitter And Receiver Binding - Horizon Hobby Spektrum AR10100T Bedienungsanleitung

EN

Transmitter and Receiver Binding

Using an AS3X SAFE
®
patible transmitter with forward programming.
Binding
The AR10100T receiver must be bound to your transmitter before it will oper-
ate. Binding is the process of teaching the receiver the specific code of the
transmitter so it will only connect to that specific transmitter. When new out of
the package, the AR10100T will automatically go into bind mode the first time
it is powered on.
1.
Connect up to two
optional SRXL2 remote
receivers (SPM9747 or
SPM4651T) and any
telemetry sensors to the
main receiver.
2.
Push and hold the bind
button on the receiver
while turning the receiver
on. Release the bind
button once the orange
LED starts to flash
continuously, indicating that the receiver is in bind mode.
TIP: It is still possible to use a bind plug in the BIND port if desired. This
can come in handy if the receiver needs to be mounted in a location that is
difficult to access, in which case a servo extension may be used for binding.
If using a bind plug, remove after binding to prevent the system from
entering bind mode the next time the power is turned on.
3.
Put your transmitter in bind mode.
4.
The bind process is complete when the orange LED on the receiver is solid.
Failsafe
In the unlikely event that the radio link is lost during use, the receiver will en-
able the selected failsafe mode. Smart Safe + Hold Last is the default setting
on the AR10100T. Preset Failsafe and SAFE Failsafe are only available through
forward programming.
SmartSafe + Hold Last
If loss of signal occurs, SmartSafe™ technology moves the throttle channel to
its preset failsafe position (low throttle) that was set during binding. All other
channels will hold their last position. When the receiver detects the signal from
the transmitter, normal aircraft operation resumes.
6
receiver requires a Spektrum
®
DSM2 /DSMX
™ ® ®
com-