Troubleshooting Guide - Horizon Hobby Spektrum AR10100T Bedienungsanleitung

EN

Troubleshooting Guide

Problem
Throttle not at idle and/or
throttle trim too high
Aircraft
will not
Throttle servo travel is lower
respond to
than 100%
throttle but
responds
Throttle channel is reversed
to other
controls
Motor disconnected from
ESC
Transmitter too near aircraft
during binding process
Aircraft or transmitter is too
close to large metal object,
Aircraft will
wireless source or another
not Bind
transmitter
(during
binding) to The bind plug is not in-
transmitter stalled correctly in the bind
port
Flight battery/transmitter
battery charge is too low
Bind button not held long
enough during bind process
12
Possible Cause Solution
Reset controls with throttle
stick and throttle trim at low-
est setting
Make sure throttle servo travel
is 100% or greater
(With battery disconnected
from aircraft) Reverse throttle
channel on transmitter
Make sure motor is connected
to the ESC
Move powered transmitter a
few feet from aircraft, discon-
nect and reconnect flight bat-
tery to aircraft
Move aircraft and transmitter
to another location and at-
tempt binding again
Install bind plug in bind port
and bind the aircraft to the
transmitter
Replace/recharge batteries
Power off and repeat bind
process