Cleaning And Maintenance; Cleaning Agents; Saturation Display - Siemens iQ700 LD97DBM60 Gebrauchsanleitung

en

Cleaning and maintenance

2Cleaning and maintenance
:
Warning – Risk of burns!
C l e a n i n g a n d m a i n t e n a n c e
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Area Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with a
soft cloth.
Clean stainless steel surfaces in the grind
direction only.
Special stainless steel cleaning products are
available from our after-sales service or from
specialist retailers. Apply a very thin layer of
the cleaning product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plastic Glass cleaner:
Clean with a soft cloth.
20
Area Cleaning agent
Glass Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Risk of electric shock caused by penetrating
moisture.
Risk of damage to the electronics from pene-
trating moisture. Never clean operating con-
trols with a wet cloth.
Do not use any stainless steel cleaners.

Saturation display

When the metal grease filters or activated charcoal
filters are saturated, the corresponding symbol will light
up or flash:
Metal grease filter: !
■
Activated charcoal filter:
■
Do not wait any longer to clean the metal grease filters
or replace or regenerate the activated charcoal filters.
Removing metal grease filter
#
Touch .
1.
Touch 0.
2.
Open the filter cover towards you.
3.
Remove the filter from the guide.
4.
Note: Fat may accumulate in the bottom of the filter
holder. Hold the filter holder at an angle to prevent
fat from dripping out.
will be lit continuously
!
will flash