Cleaning And Maintenance - Beurer HT 22 Gebrauchsanweisung

3. Switch on the device using the ON/OFF button
ON/OFF button
correct direction of use depends on which hand you are us-
ing or which side of your head you are using the device on.
The green arrows in the display
floor during use.
4. Part the hair into individual sections that are approximately
2 to 3 cm wide.
5. Hold a section taut and place it between the plates near the
roots (see Figure
6. Slowly move the device from the roots to the tips in a fluid
motion (see Figure
and land in the collection tray
7. To switch off the device, press the ON/OFF button
the green arrows disappear from the display.
8. Press the two plates together and slide the plate locking
system
3

5. CLEANING AND MAINTENANCE

WARNING
Risk of injury/crushing! Switch off the device before removing
the collection tray
cutting chamber from behind while the device is switched on!
1. Slide the collection tray
and cutting chamber
use.
2. The device housing can be cleaned with a soft cloth damp-
ened with warm water.
3. Your device is maintenance-free.
4. Protect the device from dust, dirt and humidity.
5. Do not clean the device in the dishwasher.
to select the correct direction of use. The
2
).
C
). Dry and broken hair tips are cut off
D
upwards.
from the device. Do not reach into the
5
4
should point towards the
1
.
5
on. Clean the collection tray
5
with the cleaning brush after each
17
. Use the
2
until
2
5