Transport And Storage; Disposal - Stahl 8562/5 Betriebsanleitung

Test key
The functional test should be carried out regularly during maintenance at least once every
six months, unless other regional or user-specific additional tests have been prescribed.
Maintenance Intervals
Check explosion-protected components regularly to ensure that its fitting, installation and
operation are in accordance with the regulations.
Refer to the corresponding national regulations (e.g. IEC/EN 60079-14) for the type and
scope of tests. The maintenance intervals must be chosen, such that the occurrence of
deficiences, anticipated in the system, can be avoided.
Note the following when establishing the intervals between checks:

the operating conditions (degree of utilization of the Miniatur Circuit-Breaker,
maloperation)

manufacturers' instructions in technical documentation (mechanical and electrical
service life)
 major changes in the whole system (e.g. changes of zone allocation)
Remedial Action
Any defects, which affect the explosion protection, must be remedied immediately:
 Take the device out of operation! (Disconnect it from the supply!)
 Replace the device!

11 Transport and Storage

Transport and Storage are only permitted in the original packing.

12 Disposal

Observe the national standards for refuse disposal.
149912 / 8562605300
2013-05-21·BA00·III·en·05
Transport and Storage
Residual current circuit-breaker
8562/5
9