Connection Diagrams; Commissioning; Servicing - Stahl 8562/5 Betriebsanleitung

Commissioning

8.3 Connection diagrams

2 pole
96 98
95
11536E00
Auxiliary contact 1 CO
Connect the device according to the rating plate. It has to be taken care that the neutral
conductor is connected correctly.
9 Commissioning
Before commissioning, ensure that:

the device has been installed in accordance with the standards,
 the connections have been correctly made,
 the device is not damaged,

all screws and nuts are fully tightened.

10 Servicing

10.1 Maintenance
Maintenance and repair work on the devices may only be carried out by appropriately
authorized and trained personnel.
Before any work commences, the devices must be disconnected from the supply.

Observe the relevant national regulations in the country of use!
The following items must be checked as part of the maintenance schedule:
 Check that no cable connections are loose.
 Check the plastic enclosure for cracks or other visible signs of damage.
 Check that the permitted temperatures, in accordance with IEC/EN 60079-0, are
adhered to.

Check the reset function of the switch lever.

Check that the device functions correctly.
 For function testing in the on-state, press the test key "T". The FI switch/circuit breaker
must be triggered immediately
8
Residual current circuit-breaker
8562/5
07607E00
4 pole
06 08
05
07618E00
Fault indication contact 1 CO
07609E00
96 98 06 08
95 05
12219E00
2 CO - 1 CO normal, 
1 CO Fault indication contact
149912 / 8562605300
2013-05-21·BA00·III·en·05