Acer V55 Benutzerhandbuch Seite 48

1.5.4 Reconfiguring the System
You must enter Setup after installing or removing SIMMs to reconfigure the
system.
Follow these steps to reconfigure the system:
1. Turn the system on. A memory error message appears, indicating that
the total memory does not match the value stored in CMOS.
2. Press + +
indicating an incorrect memory configuration.
3. Press twice to exit and reboot the system.
The system boots with the new memory configuration.
1.6 IDE Hard Disk Support
The system board supports four IDE hard disks, or any other IDE devices,
through the two onboard PCI IDE interfaces. See Figure 1-1 for the location.
Follow the instructions in the housing installation manual on how to install a
hard disk in the system. Connect the cables according to the IDE hard disk
configuration in Table 1-6.
Table 1-6 IDE Hard Disk Configuration
IDE Connector
Channel 1
Channel 2
1-14
to enter Setup. A warning message appears
Master
Hard disk 0 Hard disk 1
Hard disk 2 Hard disk 3
Slave
User's Guide