Herunterladen Diese Seite drucken

Dimmer Function; Temperature Protection - SCANGRIP I-VIEW Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für I-VIEW:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
UK
I-VIEW
WARNING / CHARGING INSTRUCTION / BATTERY TIPS
Avoid looking directly into the beam of light, as this will result in dazzling
Do not use the lamp near a naked flame
Recharge frequently
Do not leave the battery without charge for an extended period - Deep discharge risks damaging the battery
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole
luminaire shall be replaced
USE
To turn the I-VIEW On or Off, press the power button.
CHARGING
The I-VIEW has 4 battery status LEDs.
When the I-VIEW is charging, the LEDs will light red in the following pattern
25% charged
When the I-VIEW is off. Press and hold the power button for 2 seconds to read the remaining
battery capacity.
When the battery has less than 25 %, the last LED will flash.
100% remaining
When the charger is connected the I-VIEW will turn off.
If the I-VIEW is turned on while charging, the charging will stop. Charging will resume when the
I-VIEW is turned off.

DIMMER FUNCTION

When the I-VIEW is on, press and hold the power button to decrease/increase the brightness of the light.
The light will flash when the minimum/maximum brightness is reached.
The I-VIEW will remember the brightness level when turned off.
IR SENSOR
To activate the Infrared on/off sensor, press the "Wireless" button.
The green LEDS will turn on when the sensor is activated.
To turn the I-VIEW on/off with the IR Sensor, wave a hand in front of the I-VIEW.

TEMPERATURE PROTECTION:

The I-VIEW has a battery temperature monitor.
In case of overtemperature the brightness will be lowered or turned off until a safe battery temper-
ature is reached.
Charging will be suspended in case of over temperature.
All 4 LEDs will flash 5 times if the I-VIEW is turned off because of temperature.
Discarded electrical products must not be disposed of together with household waste. Please use recycling
facilities. Ask your local authority or retailer for advice on recycling.
- The battery must be removed from the device before it is broken up
- The device must be disconnected from the mains when the battery is removed
- Please dispose of the battery safely
50% charged
75% charged
75% remaining
50% remaining
100% charged
25% remaining
<25% remaining

Werbung

loading

Diese Anleitung auch für:

03.5626