Murray 385048x151A Betriebsanleitung Seite 21

Maintenance
Replace the Motion Drive Belt
1. Remove the mower housing. See the instructions
to "Remove the Mower Housing."
2. Completely push the pedal forward and engage
the parking brake.
3. Remove the idler pulley (1) (see Figure 16).
4. To access the belt guides (1), remove the battery
and battery tray (see Figure 17). See "Remove the
Battery."
5. Loosen the belt guides (1) at the drive pulley (2).
6. Remove the motion drive belt (3) from the drive
pulley (4) (see Figure 16).
1 1
1 2
1
7. Remove the adjuster nut (2) from the shifter
8. To remove the motion drive belt (1) from the stack
1 3 1 4
Figure 16
9. Remove the access panel (1) (see Figure 20).
10. Remove the two screws (4) that attach the steering
2
11. Remove the motion drive belt. A correct
Figure 17
bracket (3). Pull the motion drive belt over the
shifter bracket (3) (see Figure18).
pulley (2), pull the front end of the belt under the
stack pulley and then back between the stack
pulley and the steering plate (3) (see Figure 19).
2
shaft assembly. Raise the steering wheel and
steering shaft assembly. Pull the motion drive
belt (3) under the steering shaft assembly.
replacement part or assistance is available from
an authorized service center in your area.
en
1 2 3
4
Figure 18
3
1
Figure 19
21