Charging The Battery; Using A Micro Sd/Sdhc Card; Transfer Of Data Between Device And Computer - Intenso 7" INTENSOTAB Bedienungsanleitung

5.) Charging the battery

Please charge the battery completely before first use of the device. Connect the included power
adapter to the device and a power outlet. The full charge takes approximately 5 hours.
The charge condition will be displayed you during operation. In case of an active display lock, the actual
charge condition will be displayed you in percentage.
If the equipment is switched off, if you press shortly a key in any order a battery symbol will be shown on the
display. During the charge process by an animation the filling of the battery will be displayed in many levels.
If the battery is fully loaded, the animation will stop and the battery will be displayed completely.
Notes
a. With 15% remaining residual power of the battery you will get a warning message on the display. To recharge the battery, you
should now connect the device using the AC adapter to an electrical outlet to avoid possible data loss and increase the battery life.
b. You can use the device while charging the battery. To ensure long-lasting battery life, we ask you not to use the device.
c. To ensure good performance, the built-in battery must be used frequently. If you use the device often, please charge the battery
fully at least once a month.
d. Make sure you use only the included AC adapter for charging.

6.) Using a Micro SD/SDHC Card

This equipment can read data directly from a Micro SD/SDHC card. To use a micro SD/SDHC card, please
enter the card into the MicroSD card connector. Use the preinstalled Explorer (you can find further details
about it in paragraph 14) to access to the data available in the memory card. For this purpose, please
select the list "SD Card" in Explorer.

7.) Transfer of Data between Device and Computer

1.) Switch on the equipment and after that connect it with a computer.
2.) On the device the screen for the USB connection is now displayed. Tap briefly "Turn on USB
Storage". The device is recognized as a removable disk and you get the info "USB memory in use".
After briefly tapping the home button you can continue to use your device normally. You have now
have access to the internal memory of the device from your computer and can copy, delete or
transfer files to your device.
3.) If the device is connected with a computer, you can open the status bar by pressing, holding and
,
pulling down to disable the USB Memory.

To disable the memory, select "Disable USB Memory" and confirm again in the rising menu "Turn
off USB Storage".

Select on the computer the function "Safely Remove"
computer.
Note: The pre-installed applications and the Android™ operating system take up some of the existing internal memory – about 1 GB of
space is occupied. For this reason, you cannot dispose of the entire internal memory.
Please pull the status bar down to disable the USB memory.
EN - 5
to disconnect the device from the