Package Contents; Charging The Battery; Using A Micro Sd/Sdhc Card; Transfer Of Data Between Device And Computer - Intenso 8“ INTENSOTAB Bedienungsanleitung

4.) Package contents

Please check if the contents are complete:
 INTENSOTAB
 Stereo headphones
 USB cable
 Power supply 5V 2.0A
 User Manual + Warranty Card

5.) Charging the battery

Please charge the battery completely before first use of the device. Connect the included power
adapter to the device and a power outlet. The full charge takes approximately 5 hours. The charge
status is displayed on the front right side of the device. The LED lights red during charging and
switches to yellow when the battery is fully charged.
If the device is not switched on at initial operation, it now turns on automatically. This may take a
moment, because the operating system must first boot up.
Then the device starts with the key lock displayed. Here you will also see the current battery level in
percent.
If the device was already switched on, you can simply continue using the device.
Notes
a. With 15% remaining residual power of the battery you will get a warning message on the display. To recharge the battery, you
should now connect the device using the AC adapter to an electrical outlet to avoid possible data loss and increase the battery life.
b. You can use the device while charging the battery. To ensure long-lasting battery life, we ask you not to use the device.
c. To ensure good performance, the built-in battery must be used frequently. If you use the device often, please charge the battery
fully at least once a month.
d. Make sure you use only the included AC adapter for charging.

6.) Using a Micro SD/SDHC Card

This device can read data directly from a micro SD/SDHC card.
In order to use a micro SD/SDHC card, plug the card into the designated slot on the underside of the
device (10). Use the preinstalled Explorer (for details see section 14) to access the existing data on the
memory card. Please select in Explorer the directory "SD Card".

7.) Transfer of Data between Device and Computer

1.) Connect the device using the included USB cable to a computer. Should the device not have been
previously switched on, it will start automatically. This may take a moment, because the operating
system must first boot up. If device was already switched on, the computer should automatically
detect it within a few seconds.
2.) On the device the screen for the USB connection is now displayed. Tap briefly "Turn on USB
Storage". The device is recognized as a removable disk and you get the info "USB memory in use".
After briefly tapping the home button you can continue to use your device normally. You have now
have access to the internal memory of the device from your computer and can copy, delete or
transfer files to your device.
EN - 5