Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16. Install terminal of cable
black/white from wiring harness
plug XE1 (chamber 44) into
wiring harness plug X26 as
well as terminal of brown cable
and install lock latching
chamber 1
q
(cable 1, Picture 5)
cable colour black/white
chamber 2
q
(cable 2, Picture 5)
cable colour brown
7
Picture 5.
Before connecting the
compressor, make certain
that the polarity is correct.
17. Remove nut ground connection
from the body.
18. Install ground cable (eye) from
wiring harness plug X26
and tighten nut.
fasten cables with cable strap
q
to plug
connect wiring harness plug
q
clip-in wiring harness plug to
q
bracket
19. Fasten cables with insulating tape
to wiring harness
20. Install whell housing protective
panelling.
21. Install front wheel.
22. Install relay (2) and fuse (1)
(Picture 6).
Abbildung 6.
23. Install engine compartment
electronic module (UEC).
Pull positioning pins (2) down
to the stop with a suitable
tool. Tighten 3x screw (1)
(Picture 7).
Positioning pins mus be
visible again in mounted
position.
Picture 7.
24. Reprogram engine control unit,
ECC and UEC. For the ECU,
(variant programming), select
„unregulated AC",
for the ECC select "compressor
with clutch" for the UEC
select "ECC not present".
26. Check air conditioning function.
27. Erase trouble codes.
Werbung
