SmartGyro XL1 Handbuch Seite 27

Manual - XL1
Charging your smartGyro
Make sure that your smartGyro's charger is in optimal condition. Check that there is no dust or dirt in the connector and if so, clean it
and make sure it is dry. Go to the section "Product outline" of this manual where the cargo port where you must connect it is indicated.
Always use the original charger provided with the product and connect it correctly to the device (through the charging port) and to a
power outlet. It is important that you always use the charger that comes with your smartGyro, otherwise the device may fail and may not
be covered by the warranty.
When the smartGyro battery indicator light is red, it means that the product is charging. Once the product is loaded, it will take approxi-
mately two hours to complete the charge.
When the LED light turns green, it means that the product is fully charged. It is important that at that moment, disconnect the network
adapter immediately so that it stops charging. The life of the battery will be affected by the battery charging time, never exceed and
extend the life of your battery.
The first time you use the product, charge the smartGyro for about 2 hours. A full charge will take approximately 2 hours. Do not leave
the product charging once the light of the adapter has changed to green or overcharge the battery for more than 2-3 hours.
26
smartgyro.es
Charging Port
Power Button