Safety At Work; Cleaning - neumarker 308.070 Bedienungsanleitung

THERE IS NO GUARANTEE ON THE COATING!
Operating knobs/Temperature setting:
The desired temperature of the baking plates is set by the regulators.
By turning the knob the pilot light will go on which means that the unit is switched on.
the pilot light goes on
the pilot light goes off
Always make sure not to touch the hot units with bare fi ngers or hands. For hygienic and safety rea-
sons we recommend you to use wrist covering gloves. NEVER touch the hot food with bare hands.
Danger of burnings!
DANGER OF BURNINGS AND INJURIES:
Even if the upper plate has been opened until the stop, we advise you to use always one hand for
handling with a fork, spatula, etc. while the other hand is holding the handle of the upper plate.
Otherwise, by inattentiveness, the upper plate may happen to fall down.
Disconnect unit from power supply and wait until the unit has cooled down before you begin with
any maintenance or cleaning procedures.
Food residues or spots on the surfaces have to be cleaned immediately (make sure not to
burn yourself as the units could still be hot) or at the latest before Operation.
Use a dry cloth for cleaning if only slight residues have to be removed. If this is not suffi cient,
please wait until all parts of the unit have become cold, and clean with an appropriate,
non-abrasive detergent.
The Installation (only at not plug-in units) and any maintenance may only be done by author-
ized technicians. Never clean the units by a water-jet!
308070-71 en ma 2012-07
REMEMBER:
- the unit is being heated
- the selected heat has been reached

SAFETY AT WORK

CLEANING

6/7