Operating Instructions - neumarker 308.070 Bedienungsanleitung

The baking plates or cast plates become very hot during Operation. Use the unit only for the explicit
purposes, i.e. for baking and cooking cake mixtures (with wheat fl our, potato fl our or wholemeal
fl our). We strictly advise against inappropriate use.
Do not use the baking plate for heating up pots or pans. Never cover the baking plates with
aluminium foil and never place plastic basins onto the baking plate.
Installation of waffl e machines with cast iron plates:
Switch on the unit and heat it up with opened plates for approx. one hour at 180° 200° C. Smoke
might escape during this procedure as the industrial grease cover is burnt away. During this time
please spray the baking plates with our anti-adherent spray PRO 100 for approx. 3-4 times at time
distances of approx. 10 minutes. Through this procedure the rough pores of the cast iron plates will
be closed and kind of coating will be developed.
Important:
The units become very hot although they do not appear to be.
Therefore, we advise you to be very carefully when placing anything onto the cast plate.
Take care at fi lling the dough into the mould that the upper plate has been opened as far as the stop.
After fi lling the dough onto the lower plate, the unit is closed by lowering the upper baking plate.
Then adjust the timer to the demanded minutes. When the timer is over, the timer beeps and the
waffl e is ready.
Important:
We advise you to dispend exactly the recommended quantity of dough onto the plate. Otherwise the
residual liquid dough would be pressed out of the sides of the plates and will smudge your device.
During the baking procedure it might happen that steam escapes from the unit Avoid dose contact
with the steam otherwise it might cause burnings. For this reason the unit should only be opened
and closed by means of the insulated handle. Remove the fi nished baking products only by using the
appropriate Utensils such as long forks or a spatula. Never touch the plates with bare hands.
Installation of waffl e machines with aluminium coated plates:
Switch on the unit and heat it up with opened plates for approx. 30-45 minutes at 180° C. Smoke
might escape during this procedure as the industrial grease cover is burnt away. After fi nishing
this procedure, grease the plates once again with salad oil or with anti-adherent spray PRO 100 to
remove the industrial grease from the plates.
IMPORTANT:
• remove the waffl e only with a wooden stick
• clean the unit only with the attached brush or a similar one
• NEVER use abrasive detergents or sharp things
308070-71 en ma 2012-07

OPERATING INSTRUCTIONS

5/7