Installation; Operation - urmet 1067 Bedienungsanleitung

ENGLISH
GENERAL DESCRIPTION
The Ethernet interface 1067/007 is used to connect the 1067/032 or 1067/042 control panel (version 2.00
or later) or 1067/32A or 1067/052A to a LAN (Local Area Network) network or to the internet through a
modem or an ADSL router.
In this way, it is possible to control and manage the remote plant through a PC with "FastPro" Software
(supplied separately).

INSTALLATION

 Remove the power supply from the control panel.
 Place the Ethernet Interface in the desired position:
o FOR PLASTIC CASE (fig.2): position A, B, C and fixed it with the supplied screws according to the
holes D (fig.1)
o FOR METALLIC CASE (fig.3): position A, B and fixed it with the supplied screws and spacers
according to the holes E (fig.1)
NOTE: If the GSM 1067/458 module is installed, the allowed position for 1067/032 or 1067/032A is only C
(fig.2) whereas for 1067/042 or 1067/052A, it is only A (fig.3).
 Insert the Flat 10 cable into the polarized connector in position A (fig.1)
 Insert the other end of the Flat cable into the appropriate control panel connector in position F (fig.4).
 Insert the Ethernet LAN cable into the RJ45 connector shown in B (fig.1)
 Power the control panel.
NOTE: If the USB/KEY INTERFACE 1067/003 is supplied, disconnect the USB cable from the PC, before
powering the control panel.

OPERATION

The interface is directly powered by the control panel; therefore, the max. interface consumption (110 mA)
should also be considered when measuring the general input of the system.
Upon control panel start-up, the interface searches the Ethernet network. The LED on the RJ45 connector
flashes for a few seconds.
WARNING:
If the network is available, the LED 1 (fig.5) remains on and the LED 2 (fig.5) flashes to indicate data
exchange.
On the card, the LED C of fig. 1 will be on to indicate the LINK status.
If the network is not available or the cable is not correctly inserted after start-up, the LED 2 (fig.5) will flash
amber-coloured for a few seconds.
NOTE: Although there are no restrictions to use the 1067/007 and the 1067/003 on the 1067 control panel
at the same time, please note that you cannot use them together to transfer data.
DS1067-018B 5