Troubleshooting Guide - COMFORTPOOL SOLAR MAT Betriebsanleitung

5. Troubleshooting guide

Problem
The pool water is not heated.
No initial bubbling after panel is
connected and pump is on.
Bubbles continue to flow out of the
pool water inlet well after the pump
has been turned on.
Leaking solar mat
Possibilities / solutions
▪ Check to make sure that water is flowing through the tubes.
▪ Has it been sunny?
▪ Use the maximum possible solar radiation and increase the running time of the filter
pump.
▪ Put your pool cover on at night to prevent heat loss.
▪ Additional solar mats may be necessary.
▪ Check the setting of the filter system to make sure it is returning water to the pool
through the filter pump, then through the solar panel and afterwards through the
connection hose back to the pool.
▪ Check the connection hoses for possible damages.
▪ Check if the hose clamps have been tightened enough.
▪ Check the connector seals in the pipeline system.
▪ Check if the hose clamps have been tightened enough.
▪ Check the connection hoses for cracks.
|
EN
18