Malfunction And Excessive Strain; Heated Media - thermocoax ISOPAD IGB-G Serie Bedienungsanleitung

__________________________________________________________________________________
exposed heating conductors or wires, were
overheated. These products have to be
immediately put out of operation and to be
secured against reuse.
Note:
There should never be any open or short
circuits amongst the product. Check to ensure
that the system design documentation reflects
the installation and any changes that have
occurred.
Regarding temperature, the products are
manufactured out of special materials with
high demands to chemical and mechanical
stability, which also applies to the power
supply cables.
Repairs:
Repairs may be made only by authorized staff
by origin manufacturer or by enterprises
expressly authorized by this manufacturer.

Malfunction and Excessive Strain

If it has been assumed that safe operation is
no longer possible, the installation must be
permanently shut down and secured against
being inadvertently put back into operation.
This is the case, if...
...the product shows visible signs of damages
...the product is not operating according to
specification
...the product is not operating at all (no visible
indication of reason)
...the product has been exposed to excessive
strain
...the admissible product limits are exceeded
(e.g. storage, transportation,
temperature)

Heated Media

The product must not be used to heat
explosive media or
explosive gases when heated. The product
must only be installed outside hazardous
locations. When setting the temperature of
operating
media developing
the control and, if applicable, of the limiter,
the properties of the medium to be heated
have to be observed!
Attention!
During operation, the product can develop
temperatures, which may lead to burning
when touched. Therefore suitable personal
protection measures have to be taken into
consideration. When switched on, the product
must not be touched.
Environmental information for
industrial customers within the
European Union
To demand of the European Directive
2002/95/EC and of the national Product Safety
Act, equipment that is equipped with this
symbol directly provided on or with the
product and / or its packaging must not be
disposed of together with unsorted municipal
waste. The symbol indicates that the product
should be disposed of separately to regular
industrial /domestic
responsibility to use this product and other
electrical and electronic products only on the
legally prescribed methods of disposal or the
competent and of the government or local
authorities defined collection points for
disposal. Correct disposal and recycling will
help prevent potential negative consequences
for the environment and human health.
If you need further information about disposal
of your old equipment, please contact the
local authorities, waste disposal service or the
dealer from whom you purchased the
product.
waste. It is your
8 | P a g e - S e i t e