Switch On/Off The Led-Lights; Troubleshooting - Carson X10ET-XL CLIMB WARRIOR Betriebsanleitung

Switch on/off the LED-Lights

1 Your RC-Car is equipped with LED-lights in the front and backside
of the rollcage. You can switch on and off the lights by the trans-
mitter in use of the third channel.
2 In the picture there is shown the switch of the third channel to
control the LED-lights. The lighting is off when the switch is in the
middle position. If you push the switch to the upper or lower
position, thereby you activate the lights.
1

Troubleshooting

Problem
Model doesn´t move
Loss of control
Doesn´t run straight
Doesn´t stop
Doesn´t reverse
Running too slowly
CAUTION!
3 The installed lighting does not replace the daylight. Therefore,
please do not drive your model at night or in the dark. Such
obstacles can not be perceived soon enough. Thank you and
have fun!
2
Cause
Transmitter or chassis power switch is not
"ON"
Polarity or battery type is wrong
Batteries have run down
Batteries have run down
Antenna is missing or not attached properly
Steering trim is not adjusted correctly
Front and rear wheel nuts are too lose
Throttle trim is not adjusted correctly
Throttle trim is not adjusted correctly
Wrong action
Batteries have run down
Motor has lost power
Dust or foreign objects are inside gears
CARSON X10ET-XL CLIMB WARRIOR 500404056
3
Correction
Switch power on receiver or transmitter
Check polarity and type of battery
Change batteries or charge them
Change batteries or charge them
Attach receiver antenna
Make adjustment
Tighten wheel nuts
Make adjustment
Make adjustment
Control properly
Change batteries or charge them
Change to spare motor
Turn the power switch "OFF" and clean out
gears
21