FujiFilm instax mini LiPlay Bedienungsanleitung/Sicherheitsmaßnahmen Seite 10

Information for traceability in Europe
EN
Manufacturer: FUJIFILM Corporation
Address, City: 7-3, Akasaka 9-Chome, Minato-ku, Tokyo
Country: JAPAN
Authorized representative in Europe:
FUJIFILM EUROPE GMBH
Address, City: Dusseldorf Heesenstrasse 31, 40549
Country: Germany
Bluetooth® Devices: Cautions
IMPORTANT: Read the following notices before using the
product's built-in Bluetooth transmitter.
■ Use only as part of a Bluetooth network.
FUJIFILM does not accept liability for damages resulting
from unauthorized use. Do not use in applications requiring
a high degree of reliability, for example in medical devices
or other systems that may directly or indirectly impact
human life. When using the device in computer and
other systems that demand a greater degree of reliability
than Bluetooth networks, be sure to take all necessary
precautions to ensure safety and prevent malfunction.
■ Use only in the country in which the device was
purchased.
This device conforms to regulations governing Bluetooth
devices in the country in which it was purchased. Observe
all location regulations when using the device. FUJIFILM
does not accept liability for problems arising from use in
other jurisdictions.
■ Wireless data (images) may be intercepted by third
parties.
The security of data transmitted over wireless networks is
not guaranteed.
10
■ Do not use the device in locations subject to magnetic
fields, static electricity, or radio interference.
Do not use the transmitter in the vicinity of microwave
ovens or in other locations subject to magnetic fields, static
electricity, or radio interference that may prevent reception
of wireless signals. Mutual interference may occur when the
transmitter is used in the vicinity of other wireless devices
operating in the 2.4 GHz band.
■ The Bluetooth transmitter operates in the 2.4 GHz band.
The standard output is 3.16 mW.
■ This device operates on the same frequency as
commercial, educational, and medical devices and
wireless transmitters.
It also operates on the same frequency as licensed
transmitters and special unlicensed low-voltage transmitters
used in radio-frequency identification tracking systems for
assembly lines and in other similar applications.
■ To prevent interference with the above devices, observe
the following precautions.
Confirm that the radio-frequency identification transmitter
is not in operation before using this device. If you notice
that this device causes interference in low-voltage radio-
frequency identification tracing systems, contact a FUJIFILM
representative.
■ The following may be punishable by law:
– Disassembly or modification of this device.
– Removal of device certification labels.
■ Trademark Information
The Bluetooth® word mark and logos are registered
trademarks owned by the Bluetooth SIG, Inc., and any use of
such marks by FUJIFILM is under license.