Preventing Damage To The Product; Important Pre-Installation Information; Suitable Installation Site; Suitable Installation Materials - FLORABEST IAN 352928 2007 Aufbauanleitung

• The product offers protection from
direct sunlight outdoors. Due to
reflecting UV radiation, appropri-
ate sunscreen products should still
be used.
• Place the product on a flat, level
surface.
• Check regularly to make sure all
screws are tight!
• The manufacturer accepts no liabil-
ity for accidents which occur as a
result of ignoring the safety infor-
mation above or due to improper
handling.
Preventing damage to
the product!
• Secure the product during extreme
weather conditions, e.g. strong
winds. Store the product in a shel-
tered area.
Important pre­installa­
tion information
WARNING! To ensure optimal sta-
bility of the product, we recommend
fastening the floor and ceiling brack-
ets, especially on balconies or in-
stallation sites that are not at ground
level. If the product is not screwed to
the floor and ceiling, the manufactur-
er is absolved of all liability.
WARNING! Before you begin
installing the product, measure the
height between the floor and the
ceiling.
20 GB/IE
WARNING! Installing the product
requires at least two people due to
its size.
WARNING! As tools/machinery
need to be used, manual skills are
indispensable.

Suitable installation site

For ceiling installation, a concrete
ceiling or a load-bearing wood-
en beam structure is suitable.
For floor installation, a concrete
foundation or concrete slab of at
least 50 x 50 x 5cm (L x W x D) is
suitable.
Note: if you attach the product
to a wooden beam structure, you
must firmly fasten the product to it
as wood warps depending on the
temperature and humidity. Enquire
at a specialist retailer about suitable
installation materials.
Note: alternative installation condi-
tions must be checked by a special-
ist company for their load-bearing
capacity and durability.
Suitable installation
materials
Before installing the product, the
installation material must be deter-
mined.
If the installation surface is
load-bearing, the appropriate in-
stallation materials for fastening the
product must be selected.