Product Overview; Use; Charging The Storage Battery; Operation Via 12 V Car Socket - Formula 1 HI700 Originalbetriebsanleitung

Produc t Over-
view
1. Carrying handle
2. „+" button
3. „PSI BAR kPa" button
4. „-" button
5. Display
6. Operating mode toggle switch
7. Battery pack (not included)
8. USB port
9. Inflating function air outlet
10. LEDs
11. LED light toggle switch
12. Storage compartment
13. Valve quick coupling
14. High-pressure hose
15. Deflating function air inlet
16. 12 V car socket
17. Air hose
18. Bike adapter (Presta valve)
19. Valve for inflatable toys
20. Valve for sports balls

Use

Charging the storage battery

•
The storage battery should be fully charged
prior to first use.
•
Regularly check the charge of the battery pack
when stored for extended periods.
•
Fully charge the battery every month, even if
the device has not been used.
1. Connect the mains plug of the charger to a
230 V mains socket.
2. Insert the battery pack in the charger until the
battery pack clicks into place.
3. The battery will now start charging. The LEDs
on the charger indicate the current status.
Green LED Red LED
steady light steady light
flashing steady light
off flashing
flashing alternately
4. When the battery pack is fully charged, press
the release button on the battery pack and
remove the battery pack from the charger.

Operation via 12 V car socket

Connect the car plug (16) into a 12 V car socket.
Disconnect the car plug (16) from the 12 V car
socket after use and neatly wind up the cable.

Powering the unit On / Off

Auto start-up warning!
If the toggle switch (6) is in the „I" or „II" position
before switching on the device, the compres-
sor will automatically start and the air hose will
deliver compressed air. Risk of personal injury
and property damage!
1. Insert the battery pack in the device until the
battery pack clicks into place.
2. Press the „PSI/BAR/KPA" button (3). The
display (5) will light up.
3. If the device is not used for 50 seconds, the
display will automatically switch off to save
energy.

Using the LEDs

1. Set the toggle switch (11) to the
to switch on the LED lights (10).
2. Set the toggle switch (11) to the „OFF" posi-
tion to switch off the LED lights (10).

Operating the compressor

Attention!
Always wear suitable ear protectors and
safety goggles during operation!
Check the device and air hose (14) for damage
before every use! Do not use the device if dam-
aged! Check the instructions from the manufac-
turer of the inflatable before every use.
1. Remove the air hose (14) from the storage
compartment.
Hybrid Inflator HI700
EN
Meaning
Battery pack fully
charged.
Battery pack charging.
Battery pack too hot.
Battery pack defective.
position
15