Commissioning And Operation - Klarstein TRIEST Bedienungsanleitung

EN
14

COMMISSIONING AND OPERATION

Before first use
1. Take the coffee grinder out of the packaging and remove all packaging material.
2. Remove any dust that has settled on the device during the packaging process.
3. Remove the bean funnel. To do this, first press the unlocking button on the bean
funnel while turning the funnel counter-clockwise so that you can remove it from the
bean funnel holder for cleaning.
4. Clean the bean funnel, bean funnel cover, coffee powder container and coffee
container cover with water and then dry them carefully.
Caution: Never fill the bean container with water when it is connected to the device
base and never clean the device base under running water.
Commissioning
1. Place the coffee grinder on a flat surface.
2. Place the bean funnel in the bean funnel holder. Make sure that the closure of the
bean funnel is at the same height as the notch on the bean funnel holder. Now turn
the bean funnel clockwise until it is firmly connected to the holder (see Fig. 1). To
disassemble, press the release button on the bean funnel while turning the funnel
counter-clockwise to remove it from the bean funnel holder.
The bean funnel is equipped with a microswitch which ensures that the device only
works when the bean funnel has been correctly inserted into the bean funnel holder.
3. Make sure that you put a maximum of 360g of coffee beans in the bean funnel.
Note: If the device is switched on without coffee beans, it will switch off automatically
after an operating time of 5 minutes. The device must cool down for at least 30
minutes if it was previously in continuous operation for 5 minutes.