Klarstein TRIEST Bedienungsanleitung Seite 15

4. Close the bean funnel cover.
5. Place the coffee powder container (with lid) on the holder of the coffee powder
container. Make sure that the opening of the coffee powder container is level with
the coffee powder outlet.
6. Set the desired grinding degree on the grinder regulator. Turn the control to the right
to increase the grinding degree. If you turn the control to the left, the grind will be
reduced.
7. The amount of coffee depends on the grinding time. You can use the click wheel
to set the desired grinding time (see table). After the selection, the corresponding
indicator light will light up with 100% brightness. If you do not want to set a
grinding time, the device will automatically grind for the preset grinding time.
Indicator lights (from left to right)
The first LED lights up (S) with 100% brightness (factory setting)
The second LED lights up (S) with 100% brightness (factory setting)
The third LED lights up (S) with 100% brightness (factory setting)
The fourth LED lights up (S) with 100% brightness (factory setting)
The fifth LED lights up (S) with 100% brightness (factory setting)
The sixth LED lights up (S) with 100% brightness (factory setting)
8. Plug the power plug of the device into the mains socket. The first indicator light
(factory setting) will light up with 100% brightness, while the other light indicators
and the start / stop indicator will light up with 50% brightness. Select the desired
grinding degree according to 'Step 6'. Then press the start / stop button and the
machine will grind the coffee beans for the preset time. After a while, the coffee
powder will come out of the coffee powder outlet. The start / stop indicator will
flash continuously during the grinding process.
Notes:
• If no action is performed 90 seconds after switching on the device, the device will
automatically go into stand-by mode.
• If the device has been used continuously for 5 minutes, it must be allowed to cool
for at least 30 minutes. It is recommended that the device be used continuously for
less than 90 seconds per grind. A rest period of 90 minutes should be observed
after each grinding cycle.
• You can interrupt the grinding process at any time by pressing the start / stop
button.
Grinding time
in seconds
5
10
20
30
40
50
EN
15