Klarstein MAX BREEZE SMART 15K Bedienungsanleitung Seite 43

Setting the mode/function
Press the MODE button to select the desired mode: cooling, fan or dehumidification. The
corresponding indicator lights up.
Setting the temperature
1. Press the Temperature up or Temperature down buttons to adjust the temperature.
2. The screen displays the set temperature when you press the Temperature up or
Temperature down buttons. Otherwise, the ambient temperature is displayed.
3. The preset temperature of the appliance is 24 °C for cooling.
Setting ventilation speed
Press the SPEED button to select the speed. You can now set a high, medium or low
speed. The corresponding indicator lights up.
Setting the timer
1. To set the timer, press the TIMER button. You can set a time between 1-24 hours.
When the set time has expired, the appliance switches off automatically. If you
press the TIMER button, the remaining time until the power turns off is displayed. If
you do not set a time in the timer, the appliance runs continuously.
2. It is also possible, when the appliance is switched off, to set the time in the timer until
the appliance switches on automatically. For example, if you set the timer to "2",
the appliance will automatically turn on after 2 hours.
Sleep mode
1. If you press the SLEEP button in cooling mode, the temperature is increased by 1°C
after one hour, by 1°C again after the second hour and then the temperature is
maintained.
2. When the sleep mode is active, the fan speed is permanently set to low. If you press
the SLEEP button again, the appliance will run at the previously set temperature and
speed.
3. The appliance switches off automatically if the sleep mode has been active for
12 hours.
Note: The sleep mode is only available in cooling mode.
Dehumidify (DRY) mode
In dehumidification mode, the temperature cannot be adjusted and the fan speed is set
permanently low. In dehumidification mode, the appliance extracts humidity from the
environment, which is collected in a tank inside the appliance. When the water tank is
full, the appliance stops automatically. The "Water tank full" indicator lights up and an
alarm sounds. Drain the water or use continuous water drainage (see section "Draining
water").
EN
43