Troubleshooting - Klarstein BOTELLA CURA 10032026 Gebrauchsanweisung

TROUBLESHOOTING

Problem
The device does not run.
The device does not cool
enough.
The device vibrates.
The door does not close
properly.
Possible cause
The plug is not plugged in.
The device is switched off.
The fuse has been bumped
or is broken.
The environment requires
a different temperature
setting.
The door has been
opened too often.
The door does not close
properly.
The gasket does not seal
properly.
The device is not straight.
The bottles are vibrating.
There are items under the
device.
The device is not straight.
The door was reversed
and not installed properly.
The door gasket is dirty.
The shelves are not
properly inserted.
Solution
Plug the plug in.
Switch the device on.
Check the fuse.
Adjust the temperature
using the control panel.
Open the door as seldom
as possible.
Check the door gasket.
Check the door gasket.
Set the device on an even
surface.
Be careful that the bottles
are not touching.
Remove any interfering
items.
Set the device on level
surface.
Install the door correctly.
Clean the door gasket.
Insert the shelves correctly.
EN
23