uebler i21 Montage- Und Bedienungsanleitung Seite 21

2
29
5
5 27
Attention
Only attach the holder (2) to the bicycle frame, as other parts of
the bicycle could be damaged. Do not pinch components such
as gear or brake cables. Defective holders must be replaced
immediately.
Note
The lashing strap (27) can only be inserted when the twist
grip (29) is turned fully clockwise.
Note
Depending on the shape of the bicycle frame, one or both
cushions (5) can be positioned on the lashing strap (27) to
protect the bicycle frame.
11. Pass the lashing strap (27) around the bicycle frame and insert
it into the tensioning device (28) (arrow I).
12. Push the lashing strap (27) in so far that at least one belt
tooth (48) protrudes.
13. Tighten the lashing strap (27) using the tensioner (25)
(arrow II).
14. Lock the tensioner (25) and remove the key (4).
48 27
28
4
I
II
25
M+P-25A-0282
Mounting the second bicycle
The second bicycle is mounted in a similar way to the first. Note
that the bicycles are mounted in opposite directions.
Attention
Only attach the holder (3) to the bicycle frame, as other parts of
the bicycle could be damaged. Do not pinch components such
as gear or brake cables. Defective holders must be replaced
immediately.
The second bicycle is fastened using the long holder (3).
Removing the bicycles
Release the holders (4), (2) and (3) and remove the bicycles in the
reverse order.
Adjusting the clamping force
47
II
43
In the following cases, the pre-tensioning force can be readjusted:
• The clamp (42) of the locked holder (2) can be moved on the
rack frame (arrow I).
• The twist grip (29) cannot be turned clockwise as far as it goes.
Attention
The clamping force may only be adjusted once!
If the clamping force is to be adjusted again, the self-locking
nut (46) must be replaced.
1. Remove the cover (43) (for example using a screwdriver)
(arrow II).
- 19 -
3
2 42
46
29
M+P-25A-0272
I
M+P-25A-0273