Filter Parts Installation - COMFORTPOOL FORTE 19 Bedienungsanleitung

|
EN
3.6.

Filter parts installation

Insert the tube with the manifold in the tank (fig. 1) and screw the small sand guard filters to the manifold
(fig.2).
Fig. 1
Fig. 2
Place the completed manifold on the foundation in the middle of the tank and fill halfway with water to stabilize
it. Make sure that the star-shaped gauze is well centralized in the bottom of the filter and that the purge screw
is tight.
Fill the tank with filter material (see volume under section 1).
If you use sand: To prevent sand from getting into the manifold during filling, and make sure that the tube is
centered on the manifold, place the spigot (part no. 9) on the mouth of the container as shown in fig. 3 & 4.
Fig. 3
22