Powerful Pump And Large Filter Tank; Connecting To Power Source; Installation Instructions; Position Of The Filter Pump - COMFORTPOOL FORTE 19 Bedienungsanleitung

1.5.

Powerful pump and large filter tank

The system can be mounted directly on all pools with a regular pump outlet and is suitable for use with
standard hoses of Ø50 mm. Filter material and hoses for pools are not included.

2. Connecting to power source

The pump must be connected to the electric network by a 30-mA differential switch. Always disconnect the
pump from the electric network before carrying out any kind of operation on the filter or pump.
Always remember to use a ground plug and an HFI / HPFI relay.

3. Installation instructions

For the operation of the filter system, you need a skimmer (surface skimmer). Either an integrated skimmer
built into the pool wall or a suspended skimmer attached to the pool wall.
LET OP! Disconnect the plug before starting to do any work.
Before installing the filter pump unit, identify the position in which it is to be installed, as once it has been filled
up with sand, the filter is hard to move due to its weight.
3.1.

Position of the filter pump

Determine the place for the filter system between the skimmer and the pump inlet with a minimum distance of
3.5 meter between the pool wall and the filter system. We recommend placing the filter system on concrete
slabs or similar. The filter system must in no way be placed in a low place or directly on grass or soil, where
there is a risk of flooding or overheating of the motor.
3.2.

Inground or partially integrated pools

Always place the filter system under the water surface in the pool and in level with the pool floor in the pool, so
that the water can flow naturally towards the pump.
Is the system used with an inground pool, you have to place the filter system correspondingly lower into a
shaft/pit in the ground, so the water can flow by itself into the pump. Be sure that the shaft/pit stays dry. There
should be an outlet/drain to lead the water out of the shaft/pit. It is also advisable to install a submergible pump
with a float switch in case of flooding. Check that the installation is in no way closed hermetically, this could
damage the pump due to the formation of water condensation.
The size of the pit must be big enough to allow maintenance or repair of the system. Contact your supplier for
necessary spare parts like the flexible tubes, hose clamps or the filter material (not included).
|
EN
20