PALONA Tuner 190C Benutzerhandbuch Seite 49

Tuner 190C
And connect the RCA audio cable to the Line out jacks of Tuner190C and
your own speaker.
Then connect the power adaptor to the back of Tuner190C and plug it into
power socket. (Turn on your own speaker if need audio out.)
Get the network environment ready
For wired Ethernet
Use an Ethernet cable (RJ45 jack) to connect the LAN ports on Tuner190C
and your network device. Check if the light indicators on the network device
are in appropriate status.
For wireless WiFi
Make sure you have setup the wireless network and you have the WEP,
WPA or WPA2 security password to activate the connection.
You may also use the WPS (WiFi Protected Setup) function for easy
pairing between the network device and Tuner190C. Check if the light
indicators on the network device are in appropriate status.
Switch it on from Tuner190C.
At the first time operation, system asks if you want to start the Setup
Wizard. Select YES to continue the setup. Details of the Setup Wizard can
be referred to Section 5.2.1 below. After choosing NO, the next screen
asks if you would like to run the wizard next time Tuner190C is started.
Tuner190C will automatically connect to the network that was set before
when power on to Internet Radio again. In case you desire to change the
network, enter System Setting to configure the corresponding connection.
Refer to Section 5.2.1 and 5.2.3.
Press on the remote control or press Standby on the product to
enter standby mode. The time, date and any active alarm times display on
the screen. And then, press". Press on remote control or "Standby
on product to resume:
8 - EN