Proservo NMS80
Zusätzliche Information
Gauge command 2
Navigation
Voraussetzung
Beschreibung
Auswahl
Zusätzliche Information
Gauge command 3
Navigation
Voraussetzung
Beschreibung
Auswahl
Endress+Hauser
Lesezugriff
Schreibzugriff
Setup → Erweitert. Setup → Ein/Ausgang → Dig.Ein.Belegung → Gauge command 2
• Quelle Digitaleingang 1 (→ 231) ≠ Keine
• Quelle Digitaleingang 2 (→ 231) ≠ Keine
Messbefehl, welcher Digitaleingang Kombination 2 (DI2=1, DI1=0) zugeordnet ist.
• Stop
• Level
• Up
• Bottom level
• Upper I/F level
• Lower I/F level
• Upper density
• Middle density
• Lower density
• Repeatability
• Water dip
• Release overtension
• Tank profile
• Interface profile
• Manual profile
• Level standby
Lesezugriff
Schreibzugriff
Setup → Erweitert. Setup → Ein/Ausgang → Dig.Ein.Belegung → Gauge command 3
• Quelle Digitaleingang 1 (→ 231) ≠ Keine
• Quelle Digitaleingang 2 (→ 231) ≠ Keine
Messbefehl, welcher Digitaleingang Kombination 3 (DI2=1, DI1=1) zugeordnet ist.
• Stop
• Level
• Up
• Bottom level
• Upper I/F level
• Lower I/F level
• Upper density
• Middle density
Bediener
Instandhalter
Bediener
Instandhalter
Bedienmenü
233