La San Marco 2020 PLUG&PLAY 1GR Bedienung Und Wartung Seite 38

Screen 13
CYCLES ASSISTANCE
Screen 14
FILTER CYCLES
Screen 15
CHANGE WATER
SOFTENER FILTER
Screen 16
WATER SOFTENER
RESET
Service intervention cycle number technical level program-
ming screen.
This technical level programming screen is used to set the number
of cycles after which the intervention of technical service is shown
on the display.
Change the number using the + / - buttons from a value of 0 to
100000 in steps of 100. If the set value is 0, the signal is disabled
Default setting: 0 (function disabled)
If no button is selected within 30 seconds, the machine ready screen
will appear automatically (screen 2).
Each operation restarts the 30 second count.
Pressing ESC returns to the machine ready screen (screen 2).
Water softener filter change signal warning setting technical
level programming screen.
This technical level programming screen is used to set the number
of cycles after which the need to replace the water softener filter is
shown on the display.
This screen will not be displayed if the water counter was not enabled
on screen 43.
Change the number using the + / - buttons from a value of 0 to 10000
in steps of 10. If the set value is 0, the signal is disabled.
Default setting: 0 (function disabled)
If no button is selected within 30 seconds, the machine ready screen
will appear automatically (screen 2).
Each operation restarts the 30 second count.
Pressing ESC returns to the machine ready screen (screen 2).
Water softener filter replacement signalling screen.
be replaced and appears when the value set on screen 14 is reached
or exceeded.
The warning is shown for 5 seconds after each brewing operation, but
does not block the possibility of brewing coffee.
To reset the signal and make the relative counter restart from 0, press
the + / - buttons at the same time for at least 2 seconds.
Once the counter is reset, screen 16 is displayed.
Water softener filter replacement signal reset screen.
This screen signals that the water softener filter replacement alarm
was reset.
Pressing ESC returns to the machine ready screen (screen 2).
37