Disposal - Hilti HDE 500-A22 Bedienungsanleitung

Fault
The tool doesn't work and all 4
LEDs blink.
The power tool doesn't work
and 1 LED blinks.
The battery runs down more
quickly than usual.
The battery doesn't engage with
an audible click.
The tool or battery get very hot.
The foil pack cannot be tilted
and pushed down into the tool.
The foil pack holder doesn't en-
gage with an audible click.
No mortar flows out of the mix-
ing nozzle.

9 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: The burning of plastic components generates
toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal may permit
unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and
pollution of the environment.
CAUTION
Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble or incinerate the
batteries.
CAUTION
Batteries that have reached the end of their life must be disposed of in accordance with national regulations or returned
to Hilti.
All manuals and user guides at all-guides.com
Possible cause
The overload cut-out is activated; The
dispensing pressure required is too
high for the tool.
The foil pack is empty.
The battery is discharged.
The battery is too hot or too cold.
Battery condition is not optimal.
The retaining lugs on the battery are
dirty.
Electrical fault.
The power tool has been overloaded
(application limits exceeded).
The foil pack is not pushed fully into
the holder.
The piston rods are not pulled back
fully.
The retaining catches are dirty /
clogged.
The retaining lugs are defective.
The mortar in the mixing nozzle has
hardened.
Remedy
Raise the temperature of the foil pack
(observe the instructions for use of
the foil pack). Select and use a suit-
able tool for the application.
Change the empty foil pack.
Change the battery and charge the
empty battery.
Bring the battery to room temperat-
ure.
Have battery condition diagnosed by
Hilti Service or replace with a new
battery.
Clean the retaining lugs and push the
battery in until it engages. Contact
Hilti Service if the problem persists.
Switch the tool off immediately, re-
move the battery and contact Hilti
Service.
Use the right power tool for the job
(don't use a low-powered tool for
heavy work).
Push the foil pack into the holder as
far as it will go.
Press the release button and pull the
piston rods back as far as they will
go.
Clean the retaining catches and en-
gage the foil pack holder fully.
Fit another foil pack holder.
Contact Hilti Service if the problem
persists.
Unscrew the hardened mixing nozzle.
Screw on a new mixing nozzle.
en
17