Operation - Hilti HDE 500-A22 Bedienungsanleitung

6 Operation

6.1 Further instructions for use
CAUTION
Risk of pinching your fingers! Keep your hands clear
of the cradle area when pivoting the foil pack holder
into position.
WARNING
Observe the information on the safety data sheets, on
the packaging and in the instructions for use before
using the product.
WARNING
Always set the dispensing mode selector switch to
the "0" (off) position before transporting or storing
the tool. This will prevent inadvertent battery discharge
or mortar ejection.
The tool begins to operate if the trigger is pressed while
the dispensing mode selector switch is in the "dispens-
ing" position. To prevent inadvertent operation causing
battery drain or mortar being dispensed, the dispensing
mode selector switch must be left in the "off" position
during transport or storage.
Use of genuine Hilti parts ensures maximum safety. The
dispenser, the foil pack holder and the foil packs are
perfectly matched to each other.
The tool will achieve high performance, high battery
capacity and long life if handled carefully and maintained
correctly.
IMPORTANT! The motor cut-out will be activated if the
tool is overloaded. The tool relieves pressure automatic-
ally and is subsequently ready for further operation.
6.2 Dispensing mode selector switch positions
NOTE
The volume to be dispensed cannot be adjusted while
the trigger is pressed.
6.2.1 "0" (off) position
The tool is switched off.
No mortar can be dispensed.
6.2.2 Volume settings 1 to 15
NOTE
The volume settings required may vary according to foil
pack type and temperature. The values given here are to
be used as a guide.
1. Select the required volume.
1 = 1 stroke (approx. 5 ml)
15 = 15 strokes (approx. 75 ml)
2. Press the trigger and maintain pressure on it until
the tool stops automatically after ejection of the
selected volume.
All manuals and user guides at all-guides.com
6.2.3 Switch position for sustained operation
1.
2.
6.3 Selecting and inserting the foil pack
CAUTION
Check the foil pack holder for damage and/or soiling.
Both pistons must move smoothly and easily in both
directions over the full length of their travel in the foil
pack holder. Damaged and/or badly soiled foil pack
holders must be replaced.
Select the correct foil pack holder according to the color
of the foil pack.
Black foil pack holder: BLACK or WHITE foil pack
Red foil pack holder: RED foil pack
6.4 Inserting the foil pack in the foil pack holder 5
NOTE
Follow the instructions for use of the foil pack.
6.5 Discarding the initial quantity of mortar
CAUTION
The initial quantity of mortar dispensed is not suitable
for use. The quantity to be discarded is product spe-
cific and is indicated in the applicable instructions for
use. The initial quantity must also be discarded after
changing a mixing nozzle.
WARNING
Begin dispensing mortar only after the mixing nozzle
has been screwed on.
1.
2.
3.
4.
5.
Press the trigger to begin dispensing and control
the flow rate.
Increase pressure on the trigger to increase the flow
rate and reduce pressure to reduce the flow rate.
Release the trigger when you wish to interrupt or
stop the dispensing operation.
Pressure on the foil pack is released automatically
so no further mortar escapes from the mixing nozzle.
holder 1 4
dispensed
Set the mode selector switch to "continuous opera-
tion".
Press the trigger until the mixing nozzle is completely
full.
Set the dispensing selector switch to the mortar
volume to be discarded (number of strokes) in ac-
cordance with the instructions for use of the mortar.
Discard this initial quantity of mortar dispensed.
The tool is then ready to dispense ready-to-use
mortar.
en
15