Electrical Connections; Details On Installation In The Bathroom - Fondital eBlitz Wi-fi Installations-, Betriebs- Und Instandhaltungsanleitung

2.

ELECTRICAL CONNECTIONS

IMPORTANT
During installation, maintenance and cleaning, the appliance must not be powered.
The appliance must be powered only with 230 Vac voltage.
The radiator is supplied with a power cable with 3 wires as per table below:
Brown Phase
Blue or Grey Neutral
Black Pilot wire
The power cable must be absolutely connected to power supply through a junction box positioned at 25 cm from the floor and
without using any power plug.
WARNING
The Pilot Wire is intended for radiators sold in France.
If the black "pilot wire" is not used, safety standards impose to insulate it and not to connect it for any reason to the
ground wire.
It is compulsory to install a multipolar switching device. The minimum separation distance between contacts shall
be at least 3 mm.
It is compulsory that the power supply circuit of the appliance is protected by a high sensitivity differential protection device.
Do not introduce and do not try to penetrate with metal objects into the side of the radiator containing the adjustment electrical
system (right side). If the power cable is damaged, it must be replaced only by a qualified electrician.
2.1

DETAILS ON INSTALLATION IN THE BATHROOM

Installation must be compliant with the standards and laws in force in the country of installation.
The radiator is in class II and with IP24 electrical protection. In the bathroom, it can be installed in areas 2 and 3 (see figure) only
if the control device cannot be touched by people that are using the shower or the bath.
In the bathroom, protect the power line with a high sensitivity 30 mA differential protection device
Install a multipolar switching device. The minimum separation distance between contacts shall be at least 3 mm.
EN - 25
figura n°1