Items Supplied; Proper Use; Important Notes; Noise Emission Values - HERKULES ZGS 33-- UG Bedienungsanleitung

Anleitung ZGS 3300 UG_SPK7:_
1. Layout (Fig. 1/2)
1. Release lever
2. Handle
3. ON/OFF switch
4. Machine head
5. Saw blade
6. Movable blade guard
7. Stop rail
8. Turntable
9. Stationary base plate
10. Locking grip
11. Pointer
12. Dial for turntable
13. Locking lever
14. Thumb screw
15. Scale
16. Safety pin
17. Saw shaft lock
18. End stop

2. Items supplied

Crosscut and miter saw
Clamping device (19)
Extension supports
Carbide-tipped blade (5)
Sawdust bag (24)
Key for changing the blade (32)

3. Proper use

The drag, crosscut and miter saw is designed to
crosscut wood and plastic commensurate with the
machineʼs size.
The machine is not to be used for cutting fire wood.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The machine is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off
wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
06.06.2007 14:52 Uhr Seite 9
All manuals and user guides at all-guides.com
GB
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following hazards may arise in
connection with the machineʼs construction and
design:
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Important notes

Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.

Noise emission values

The sawʼs noise is measured in accordance with
DIN EN ISO 3744; EN 60651; 6/93, ISO 7960
Annex A; 2/95. The machine may exceed 85 db
(A) at the workplace. The user will require noise
protection measures if this is the case. (Wear
ear-muffs!)
Idle speed
Sound pressure level L 95,9 dB
pA
Sound power level L 108,9 dB
WA
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
9