Troubleshooting; Ec Declaration Of Conformity - Kity 3301415901 Originalanleitung

We, Scheppach Fabrikation von Holzbearbeitungsmaschinen GmbH & Co. KG, Günzburger Str. 69, D-89335 Ichenhausen, hereby de-
clare that the machine named below correspondends to the relevant safety and health requirements of the EC guidelines specified below
in its design and construction and in the version which we introduced to the market.
This declaration becomes invalid if changes are made to the machine without our consent.
Machine description:
Circular saw
Machine model:
415
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009), EC machine directive 2006/42/EG (> 29.12.2009), EC Low voltage directive 2006/95/
EWG, EC-EMV directive 2004/108/EWG.
Applied harmonized European Standards:
EN 12100-1, EN 12100-2, EN 294, EN 349, EN 418, EN 847-1, EN 13849-1, EN 1088, EN 1870-1, EN 60204-1, EN 55014, EN 60555-2,
EN 60555-3
Applied national technical standards and specifications, especially:
ISO 7960
Notified body within the meaning of Annex VII
Prüf- und Zertifizierungsstelle
Fachausschuss Holz
Vollmoellerstraße 11
70563 Stuttgart-Vaihingen
Enganged for
(EG-Baumusterbescheinigung) HO 081087
Date:
Ichenhausen, 02.07.2009
on behalf on Wolfgang Windrich
(Technical manager, beneficary)
Failure
Saw blade gets loose after turning off the motor
Motor does not start
Motor runs forward or backward
No motor output, turns off automaticallly
Burns on the cutting surface
c) Longitudinal cuts
d) Withe cross cuts
EC Declaration of Confirmity

Troubleshooting

Possible Cause
Fastening nut tightened insufficiently
a) Fastening nut tightened incufficiently
b) Extension cable defect
c) Connections on the motor or switch defect,
Brake does not bleed
d) Motor or switch defect
Capacitor defect
Overload by dull saw blade, thermoproteciton is
triggered
a) Fastening nut tightened insufficiently
b) Wrong saw blade
c) Longitudinal stop not parallel
d) Slide carriage not parallel
23
Solution
Tighten fastening nut, M20 left-handed thread
a) Check the main fuse
b) See „Elecrical Connection"
c) Have it checked by an electrician
d) See „Electrical Connection"
Have it exchanged by an electrician
Insert a sharpened saw blade; motor can be
turned on again after the cooling period
a) Insert a sharpened saw blade
b) Insert a saw blade with 20 or 28 theeth for
longitudinal cuts
c) Exchange the longitudinal stop
d) Align the slide carriage with the sawblade
D GB