Functional Description - Makita BO4565 Bedienungsanleitung

SANDER SAFETY WARNINGS
1. Always use safety glasses or goggles.
Ordinary eye or sun glasses are NOT safety
glasses.
2. Hold the tool firmly.
3. Do not leave the tool running. Operate the tool
only when hand-held.
This tool has not been waterproofed, so do not
4.
use water on the workpiece surface.
5. Ventilate your work area adequately when you
perform sanding operations.
6. Some material contains chemicals which may
be toxic. Take caution to prevent dust inhala-
tion and skin contact. Follow material supplier
safety data.
7. Use of this tool to sand some products, paints
and wood could expose user to dust contain-
ing hazardous substances. Use appropriate
respiratory protection.
8. Be sure that there are no cracks or breakage
on the pad before use. Cracks or breakage
may cause a personal injury.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► Fig.1: 1. Switch
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
To start the tool, press the " I " side of the switch. To
stop the tool, press the " O " side of the switch.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive
paper
NOTE: Use Makita hook-and-loop sandpaper with
this sander.
To attach the sandpaper:
► Fig.2: 1. Velcro sandpaper 2. Base
► Fig.3: 1. Velcro sandpaper 2. Base
► Fig.4: 1. Base 2. Velcro sandpaper
1. Set the tool upside down so that the pad is on top.
2. Position the sandpaper to fit the shape of the base.
Be sure to align the holes on the sandpaper with the
holes on the pad (the dust will be sucked into these
holes; it is therefore important to leave them open).
3. Press the paper firmly over the pad.
To remove the sandpaper:
1. Set the tool upside down so that the sandpaper is
on top.
2. Grasping one corner of the sandpaper, peel it from
the pad.
NOTE:
• If the sandpaper is in good condition, save it for
further use.
When sanding in narrow, hard-to-reach areas (e.g.,
shutters, blinds, louvers), attach the cone-shaped
abrasive papers to the end of the pad (bottom and top).
To sand the end of thin materials, fold the abrasive
paper and attach to the side of the pad as shown in the
figures.
Dust bag (accessory)
► Fig.5: 1. Dust bag
The use of the dust bag makes sanding operations
clean and dust collection easy. To attach the dust bag,
fit the bag's entry port onto the dust spout on the tool.
Make sure that the hole in the bag's entry port is just
over the pimple-like protrusion on the dust spout.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
Installing paper dust bag
(accessory)
► Fig.6: 1. Groove 2. Front fixing cardboard 3. Front
side of paper dust bag
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing card-
board of the paper dust bag into the groove of the paper
dust bag holder.
5 ENGLISH