Herunterladen Inhalt Inhalt Diese Seite drucken

Water Softener; Adjusting Salt Consumption - Scandomestic SFO 4901 W Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Water Softener

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your
local Water Authority can advise you on the hardness of the water in your area.

Adjusting salt consumption

The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the program button for more
than 5 seconds to enter the water softener setting mode.
3. Press the program button again to select the proper set according to your local
environment, the setting will change in the following sequence:
H3->H4->H5->H6->H1->H2->H3;
4. Without operation in 5 seconds or press the Power button to complete the setup and exit
the setup mode.
WATER HARDNESS
German
French
dH
fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
23 - 34
41 - 60
35 - 55
61 - 98
1°dH=1.25 °Clarke=1.78 °fH=0.178mmol/l The manufactory setting: H3
1) Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
British
Mmol/l
Clarke
0 - 6
0 - 0.94
7 - 14
1.0 - 2.0
15 - 21
2.1 - 3.0
22 - 28
3.1 - 4.0
29 - 42
4.1 - 6.0
43 - 69
6.1 - 9.8
Water softener
level
H1-> Rapid Light
bright
H2-> 90 min Light
bright
H3-> 90 min, Rapid
Light bright
H4-> Glass Light
bright
H5-> Glass, Rapid
Light bright
H6-> Glass, 90 min
Light bright
Regeneration
Salt consumption
occurs every X
(gram/cycle)
program
sequence 1
No regeneration
0
10
9
5
12
3
20
2
30
1
60

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sfo 4901 x

Inhaltsverzeichnis