Lcd Display; Technical Parameters - auna MD120 Anschluss- Und Anwendungshinweise

7. MEN
Under radio mode, short press this button, when the LCD shows SEL, short press this button twice
again, can change the band: FM1—FM2—FM3, then short press volume knob to confirm. long press
to search and save the stations automatically.
Under music playing mode, short press this button, when the LCD shows SEL, then Continuous
pressing volume knob to enter the selection as following:
Bass→Treble→Balance→Fader→Loudness→EQ
Bass/Treble/Balance/Fader selection: when the LCD display BAS, TRE, BAL or FAD, then rotate the
volume knob to adjust.
Loudness: when the LCD display LOUD, then rotating the volume knob to
turn on or turn off.
EQ: when the LCD display EQ, selected the EQ as following: Jazz→Classic→Pop→Rock→Off
by rotating the volume knob.
Long press to enter into song selected function, rotate the Volume knob to select the number, then
short press volume knob to next numbers, with same operation to choose the numbers, then short
press MEN to confirm.
8. AUX-In
Outer connection signal input.

9. LCD Display

Display the channel of radio or the playing information.
10. SD/MMC Card Slot
Insert the SD or MMC card, the system will play it accordingly
11. USB Slot
Insert the USB, the system will play it accordingly.
Tuner Part:
Frequency Range
Intermediate frequency
Signal to noise ratio (S/N)
Play Part:
Signal to noise ratio (S/N)
Channel Separation (1 KHZ)
Voltage Harmonic Distortion
Frequency Response
Amplifier Part:
Output
Speaker Impedance
Power source
Car battery (the negative pole connect ground, see on the unit in detail)
CAUTIONS
When replacing the fuse, please check that the fuse is of the same specification.

Technical Parameters

87,5MHz-108MHz
10,7MHz
50>dB
50>dB
50>dB
<5%
100Hz-10kHz (+6dB)
speaker output
4Ω-8Ω
12V DC