Panasonic JS-950-Serie Bedienungsanleitung Seite 22

2. How to replace the ID module block
(1) Remove Display Block according to Display Block Installation.
(2) Prepare an ID module block to be used.
* The ID block unit is supplied with 2 pieces of peripheral screws, 2 pieces of screws, 1
piece of long cable cover, and 1 piece of short cable cover as accessories.
(3) Slide the USB cable cover toward you while pushing both sides of the USB cable cover at
the hinge section of the display block inward to remove the cover.
(4) Disconnect the connector of the ID module block from the connector of the main block, and
detach the cable from the guide channel.
(5) Remove the 2 screws on the rear side of the display block using a screwdriver.
After removal of the screws, the peripheral screws can be removed from the front side of
the mounted ID module block.
(6) Perform replacement in accordance with the procedure 1, "How to mount the ID module
block".
22