Panasonic JS-950-Serie Bedienungsanleitung Seite 16

■ Storage Block Installation
Be sure to disconnect the power cable of the main block (POS Workstation) and confirm
the power is "OFF" before the operation below.
1. How to mount the storage block
(1) Disconnect the 2 latches on the upper portion of the filter cover of the main block by both
hands, pull the cover toward you while pressing the cover downward at the same time, and
remove the filter cover.
(2) Insert the storage block into the prescribed inlet of the main block slowly and connect the
connector of the main block with the connector of the storage block.
(3) Tighten the 2 thumbscrews supplied with the main block by hand to secure the storage
block.
(4) Hitch the lower portion of the filter cover to the main block, and push the cover until the
latches of both sides on the upper portion are connected to secure the cover.
(3)
(1)
(4)
16
(2)