Intended Use; Height Adjustment - Steelcase Solo Sit-to-Stand Desk Kurzanleitung

3. Intended use

Intended use also includes following all instructions in the user guide.
The Solo Sit-to-Stand Desk is exclusively designed to be used as office furniture for both private and commercial
use. Any other use or use beyond the specified intended use is considered improper use.
Improper use of the product can result in a risk to life and limb or material damage. For these reasons, improper
use is prohibited. In the case of improper use, Steelcase assumes no liability for any damage that may occur and
does not guarantee that the components will function properly. Improper use includes:
Lifting loads
■
Use as a climbing aid
■
Use for the permanent storage of objects with a
■
total weight exceeding 75 kg

4. Height adjustment

Optimum desk height
Adjustment to the optimum desk height (sitting height) is crucial for the correct sitting posture at
the workstation. The correct desk height setting for the workstation can be found in the
workstation analysis (pursuant to the German Occupational Safety and Health Act, the German VDU
Workplace Ordinance, or accident prevention regulations, for example). See also BGI 650:
Computer and office workstations. Guidelines for design.
4.1 Lift 2 variant
ATTENTION
EN
Before first use, ensure that
The desk has been assembled correctly.
■
There is no-one on the desk.
■
There are no people or objects in the lifting range.
■
The maximum permissible desk load-carrying capacity is not exceeded.
■
The control panel is connected to the controller.
■
All safety instructions have been followed.
■
4.1.2 Height adjustment
 Press the appropriate "Up or Down" button to reach the desired desk height.
The desktop moves up or down.
=
Release the "Up or Down" button.

The desktop stops at the desired point. The display indicates the desk height.
=
The buttons on the control panel have to be held down to move the desktop.
158069
Solo Sit-to-Stand Desk
Outdoor use
■
Use in damp rooms
■
Rev. A