Hepa Filter Cleaning / Replacement; Operation - Clever Clean Fusion MX 12 Gebrauchsanleitung

HEPA FILTER CLEANING / REPLACEMENT

• Clean / replace the HEPA filter only when the unit is switched off.
• Cyclone filters and HEPA filters are not suitable for washing machines, dishwashers or dryers.
• Before cleaning/replacing the HEPA filter, please empty the dust container (see chapter Emptying the
dust container).
• Remove any accessories from the suction opening of the main unit.
• Press the release button on the top of the main unit and then turn off the dust container.
• Then pull the dust container forward from the main unit.
• Cyclone and HEPA filters can now be pulled out of the dust container by grasping the two round
openings on the Hepa filter with two fingers.
• The Hepa filter can then be separated from the cyclone filter by turning it.
• The cyclone filter can be cleaned with a damp cloth.
• The HEPA filter must NOT be cleaned with water. Knock out the HEPA filter or clean it carefully with a
soft brush.
• The assembly is carried out in reverse order.
26

OPERATION

• Make sure that there are no large, sharp objects on the surface to be cleaned.
• If the dust container is too full during use, empty it. Empty and clean the dust container after each
use. The Hepa filter must also be cleaned regularly to avoid overloading the motor.
• Switch off the device after each cleaned surface, thus significantly increasing the operating time per
battery charge.
• When the device is switched on, the charge status of the battery is indicated by the LED display on
the back of the device. When the battery is fully charged, all LEDs light up, and when the battery
becomes weaker during use, the number of LEDs light up is reduced.
• Select accessories as required and attach to the unit.
• Switch on the device. To do this, press the on/off switch firmly once, it engages and the unit
immediately starts the suction process. To switch off the unit, press the on/off switch again.
• Move the unit over the area to be cleaned.
• Switch off the appliance after vacuuming.
• For optimum performance of the unit, empty the dust container after each use and clean if necessary.
Use of the articulated joint on the suction pipe
Unlock the articulated joint by pressing the unlocking button on the underside of the suction pipe. This
will allow you to easily reach hard-to-reach places, such as under furniture.
If you no longer need the knee joint, bring it back into a straight position and make sure that the locking
mechanism clicks audibly into place again.
Turbo Boost Function
The device is equipped with two Turbo Boost levels. This significantly increases the suction power, but
reduces the operating time per battery charge when the Turbo Boost function is switched on.
To activate the Turbo Boost function, touch the Boost button on the back of the unit in the middle of the
LED battery charge indicator. The Turbo Boost function has two levels: a single press switches to the first
level, another press switches to the second level. To switch off the Turbo Boost function again, touch the
button again.
27