Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
User Manual
Soldering iron kit 30 W
1.
Touch the parts to be soldered with the heated soldering tip.
2.
Immediately apply some solder to the solder joint.
The flux cleans the solder so that the solder tin adheres in a better way.
It creates a good heat transfer, and the solder joint will quickly warm up.
3.
Always leave the soldering iron in contact with the solder joint
during the soldering process.
4.
Remove the soldering iron after the solder has been correctly.
5.
Allow the solder to cool down and don't burden them within
this time.
The rosin is slightly acidic and should be used only when oxidized solder
brazing in addition, because the solder already contains flux.
6.
Clean the soldering tip after each use.
7
Replacing the soldering tip
Caution! Only change soldering tips when the unit is switched off
and has cooled down.
The soldering tip and the front part of the soldering iron
become hot when plugged in.
1.
Loosen the screw connection with which the used soldering
tip is attached to the soldering iron.
2.
Remove the used soldering tip.
3.
Push the new soldering tip in as far as it will go and screw it
tight.
4.
Burn the new soldering tip before use to remove any residue.
8
Maintenance, Cleaning, Storage and
Transport
The products are maintenance-free.
• Always unplug the appliance and let it cool down first!
• Ensure sufficient ventilation even during work breaks and while the
unit is cooling down.
• Check the screw connection with which the soldering tip is fixed
regularly for a tight fit and retighten it if necessary.
• Only use a dry and soft cloth for cleaning.
•
Do not use cleaning agents and chemicals.
•
Store cool and dry.
•
Store the product out the reach of children and in a dry and dust-
protected ambience when not in use.
•
Keep and use the original packaging for transport.
9
Liability notice
We reserve the right to printing errors and changes to product, packaging
or product documentation.
•
See our terms of warranty. These are available in their current
form under the given contact details.
10
Disposal Notes
10.1
Product
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its components
must be recycled or disposed apart from each other. Otherwise contami-
native and hazardous substances can pollute our environment.
As a consumer, you are committed by law to dispose electrical and electronic de-
vices to the producer, the dealer, or public collecting points at the end of the devices
lifetime for free. Particulars are regulated in national right. The symbol on the pro-
duct, in the user`s manual, or at the packaging alludes to these terms. With this kind
of waste separation, application, and waste disposal of used devices you achieve an
important share to environmental protection.
WEEE No: 82898622
REV2020-07-21
V2.1 ir
Subject to change without notice.
10.2
Packaging
Packaging can be disposed of free of charge at the suitable collection
points – paper belongs in paper bins, plastics belong in yellow sacks and
glass belongs in used glass bins.
DE4535302615620-V
11
EU Declaration of Conformity
With the CE sign, Goobay
GmbH ensures, that the product is conformed to the basic European
standards and directives.
- 4 -
, a registered trademark of the Wentronic
®
by Wentronic GmbH | Pillmannstraße 12
38112 Braunschweig | Germany
45242
Goobay
®
Werbung
