Maintenance; General; Trouble Shooting; Daily Maintenance - KLIPPO ENERGY Bedienungsanleitung

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by an authorized service workshop.
Inspection and/or maintenance should
be carried out with the motor switched
off and the plug disconnected.
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest service workshop.
• Let your Klippo dealer regularly check the machine
and make essential adjustments and repairs.
• Always use genuine accessories.

Trouble shooting

Problem Cause
The power cable
is not connected.
Engine
does not
The engine
start
overload
protection has
tripped out
The connection
cable is too long
The engine
and/or the cross
hums but
cut area of the
does not
cable is too small
start
Capacitor ou of
order

Daily maintenance

General inspection
• Check that the machine's safety equipment is
undamaged. See instructions in the section
"Machine's safety equipment".
• Check that nuts and screws are tight.
• Check that the cord and extension cord are intact and
in good condition. If the power cable is damaged the
machine must be brought to an authorized service
dealer to be replaced. Never repair a damaged cable.
• Check the cutting attachment. See instructions under
the heading "Cutting equipment".
54 – English

MAINTENANCE

Action
Connect the power
cable to a suitable
socket.
Remove the reason
for the overload (too
much grass, twigs
etc.). Wait a few
minutes before
attempting to
restart.
Change to a shorter
power cable or to a
cable with a larger
cross-section
Contact your
service agent.
External cleaning
• Brush leaves, grass and the like off of the lawn mower.
• Do not use a high pressure washer to clean the
machine.
• Do not wash the machine with water, as water can
enter the electrical system or the engine and cause
damage to the machine or short circuit.
• Keep the machine clean and dry both underneath and
on top.
Air filter
• Dismantle the filter cover to inspect the air filter. Blow
out the filter using compressed air.
• An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
Contact your service agent for replacements.
Vibrations
If heavy vibration occurs, stop the machine. Check the
cutting attachment. See instructions under the heading
"Cutting equipment". Contact your service workshop if the
problem remains.

Cutting equipment

• Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be
replaced.
• Always ensure the cutter is well ground and balanced
correctly.
Replacing the blades
WARNING! Always wear heavy-duty
!
gloves when servicing and maintaining
the cutting equipment. The cutters are
very sharp and cuts can occur very
easily.
Dismantling
• Unscrew the bolt holding the cutter.
• Remove the old blade. Make sure the blade bracket is
free of damage. Also check that the cutter bolt is
undamaged and that the engine shaft is not bent.
Assembly
• Fit the new blade with the punched text facing the
blade bracket.
• Tighten the nut firmly (approx. 30 Nm). Pull the blade
around by hand and make sure it rotates freely.
• Test run the machine.