Other Convenient Rds Functions; Automatic Selection Of The Station When Using The Number Buttons; Changing The Display Mode While Listening To An Fm Station; Setting The Ta Volume Level - JVC KD-S656R Bedienungsanleitung

Other convenient RDS functions

Automatic selection of the station when using the number
buttons
Usually when you press the number button, the preset station is tuned in.
However, when the preset station is an RDS station, something different will happen. If the
signals from that preset station are not sufficient for good reception, this unit starts searching
another station broadcasting the same programme as the original preset station is broadcasting,
then if any station broadcasting the same programme is found, the station will be tuned in.
Changing the display mode while listening to an FM
station
You can change the initial indication on the display to station frequency, station name (PS), or
clock time while listening to an FM RDS station.
• See also "Changing the general settings" on page 25.
1. Press and hold SEL (select) for more than 2 seconds to call up the general settings mode.
¢ or 4
2. Select "DISPMODE" with .
3. Set to the desired indication (station frequency, clock time, or station name) with the level
control buttons (+,–).
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the display changes to show the following:
Station name Frequency
Clock time
PTY (Programme type)
* The display returns to the initially preset mode after a short while.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
• See also "Changing the general settings" on page 25.
1. Press and hold SEL (select) for more than 2 seconds to call up the general settings mode.
¢ or 4
2. Select "TA VOL" with .
3. Set to the desired volume level with the level control buttons (+,–).
15