Settings and adjustments
3. Use your upper body to push the backrest
backwards into the right position, or:
4. Bend your upper body forward to allow the
backrest to move forward automatically.
5. Release the lever (S).
The backrest is now locked in its current
position.
Armrests
Attention
The position of the armrests changes if the
position of the backrest is adjusted.
1. Rotate the armrest upwards/downwards to
the desired angle.
2. Use the adjusting wheel (R) to lock the angle
of the armrest.
3. Loosen the adjusting wheel (R) to move the
armrest down.
Backrest lumbar support
1. Press the lumbar pump (M) a couple of
times.
The curve of the backrest increases.
2. Check if the new setting has the desired
result.
3. Press the lumbar unlocking button (N) to
decrease the curve.
Adjusting the handlebars
Caution
Do not pull the handlebars upwards too
firmly when adjusting; the maximum setting is
8 cm.
Attention
Have your dealer set the handlebar height in
the correct position once and for all before
using the mobility scooter.
GB20
R
Change armrest angle
N
M
Set backrest lumbar support
V
Adjust the steering height
U
Adjust the steering angle
Settings and adjustments
Do not adjust the angle of the steering
column while driving. A gas spring allows the
handlebars to move forward independently.
Handlebar height
1. Loosen the (socket) screw (V) using an Allen
key.
2. Adjust the height of the handlebars.
3. Tighten the screw again firmly.
Steering column angle
1. Sit down on the seat.
2. Pull lever (U) towards you.
3. Pull the steering column towards you or push
it away until you reach the desired position.
4. Release the lever.
The steering column is now locked in place.
GB21