Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. INSTALLATION AND USE
Bottom Mount
Inspect the equipment according to INSPECTION of this manual before each use.
The EAP Beam Fix could be installed on any I-beam for both Horizontal and Vertical use. The EAP Beam Fix
could be located on the top, bottom (horizontal) or side (vertical) of I-beam.
Step 1
Remove the quick release lock pin. Open the adjustable beam block by turning the tightening
handle counter-clockwise. Then press the safety lock to adjust the beam size.
Step 2
Place the EAP Beam Fix onto beam flange in your required position (top, bottom, side).
Step 3
Place fixed beam clamp against one side of the beam flange. Slide the adjustable clamp against
opposite side of the beam flange.
Step 4
Ensure the safety lock is in nearest position to the beam flange.
Step 5
Insert the quick release lock pin to fix the safety lock, ensuring pin is locked into place.
Step 6
To secure the EAP Beam Fix onto the flange, swivel the tightening handle away from the hexago-
nal rod and turn adjustment handle clockwise in half turns. Ensure beam clamps are tight against
both sides of the flange. Only hands tighten is allowed. Ensure the quick release lock pin has not
bottomed out. If adjustment pin has bottomed out, reinstall the EAP Beam Fix to the next locking
position. If the quick release lock pin is damaged or absent, the equipment is still in workable
condition. However, for safety concerning, when the quick release lock pin is damaged or absent,
the equipment must be sent back to your dealers, distributors, or manufacturer to replace a new
quick release lock pin.
Top Mount
INSTALLATION AND USE
Side Mount
15
Werbung
Inhaltsverzeichnis
