Training; Inspection - TEUFELBERGER EAP BEAM FIX 7331928 Herstellerinformation Und Gebrauchsanleitung

TRAINING / INSPECTION

6. TRAINING

It is the responsibility of the users to assure they are familiar with the instructions, and are trained in the
correct care and use of this equipment. Users must also be aware of the operating characteristics, application
limits, and the consequences of improper use of this equipment.

7. INSPECTION

FREQUENCY:
Before each use, inspect the EAP Beam Fix according to following steps and see EAP BEAM FIX COMPO-
NENTS for part identification.The EAP Beam Fix must be formally inspected by a competent person other
than the user at least annually. Record the results in the inspection and maintenance log in INSPECTION
AND MAINTENANCE LOG.
INSPECTION STEPS:
Step 1 Inspect EAP Beam Fix for damage: Look for cracks, dents, or deformities. Look for bending or
wear on the hexagonal rod, beam clamps, quick release lock pin, and tightening handle. Ensure no
parts are missing.
Step 2 Inspect entire unit for excessive corrosion.
Step 3 Ensure the quick release lock pin can be inserted through the hole on safety lock button, and locks
in place.
Step 4 Record the inspection date and results in the inspection and maintenance log.
If inspection reveals an unsafe or defective condition remove unit from service and destroy, or return to
TEUFELBERGER for repair.
NOTE
Only TEUFELBERGER or parties authorized in writing are qualified to repair this equipment.
16